Mechanical units

Force and Torque Unit Converter

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison. Enter the application values to calculate four decision-ready outputs and review the governing assumptions before selecting equipment.

Use calculator All tools

Mechanical units

Run the calculation

Engineering visual

Force & Torque Converter calculation path

The physical quantity stays unchanged while its numerical value and unit notation are expressed on equivalent scales.

01Quantity type
02Calculate and compare
03Primary SI result

Primary SI result

Secondary SI result

Primary imperial result

Gravitational or secondary imperial result

Calculation reference

What this tool checks.

Use the displayed relationship to understand how the entered conditions affect the result. Treat the output as a preliminary selection, then verify actual operating conditions, catalog limits, and safety margin.

Inputs

Quantity type
Entered value
Entered unit

Outputs

Primary SI result
Secondary SI result
Primary imperial result
Gravitational or secondary imperial result

Engineering guide

Use the result with the right context.

Calculate force & torque converter for a pneumatic application and compare the result with supplier data.

Calculation workflow

Enter Quantity type, Entered value, Entered unit and replace every default with application data.
Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.
Interpret Primary SI result, Secondary SI result, Primary imperial result against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits

The converter changes units only and does not repair an incorrect gauge, absolute, standard, normal, or actual reference basis.
Keep the original datasheet reference conditions with the converted value.

How to use the Force & Torque Converter

Start with measured or supplier-confirmed values for Quantity type, Entered value, Entered unit. The calculator updates all outputs together, making it easier to see which assumption controls the preliminary selection.

What the result means

Primary SI result, Secondary SI result, Primary imperial result, Gravitational or secondary imperial result answer different parts of the same engineering question. Use the primary result for selection, the secondary values to audit units and margins, and the visible formula to reproduce the calculation in an RFQ worksheet.

Engineering limits

The converter changes units only and does not repair an incorrect gauge, absolute, standard, normal, or actual reference basis. Keep the original datasheet reference conditions with the converted value. Final approval requires the current manufacturer datasheet and validation under installed conditions.

FAQ

Common review questions.

01Tool noteWhat does the Force & Torque Converter calculate?

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison. It returns Primary SI result, Secondary SI result, Primary imperial result, Gravitational or secondary imperial result so the primary answer and its supporting checks stay together.

02Tool noteCan I use the result as a final component selection?

Use it for preliminary engineering and RFQ comparison. Final selection must include supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Force & Torque Converter?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.