AI Search

Search this site

Compressor efficiency

Air Compressor Specific Power Calculator

Calculate compressor specific power, kW per 100 cfm, cfm per kW, and hourly electrical energy from measured input and FAD.

Compressor efficiency

Run the calculation

Calculate compressor specific power, kW per 100 cfm, cfm per kW, and hourly electrical energy from measured input and FAD.

Engineering inputsCompressor Specific Power Calculator

Enter the known application values. Outputs update instantly as units or assumptions change.

FAD unit
Use these values for preliminary sizing before final datasheet review.

Engineering visual

Compressor Specific Power Calculator calculation path

The compressor converts electrical input into compressed-air output and heat. Capacity, pressure, specific power, and recoverable heat are shown by energy path.

Compressor Specific Power Calculator calculation pathThe compressor converts electrical input into compressed-air output and heat. Capacity, pressure, specific power, and recoverable heat are shown by energy path.MOTORCOMPRESSORη / kWAIR Q @ pRECOVERABLE HEAT
  1. 01Measured package input power
  2. 02Calculate and compare
  3. 03Specific power
Specific power
kW per 100 cfm
Flow per input kW
Energy per operating hour

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Measured package input power
  • Free air delivery
  • FAD unit
  • Measured load fraction

Outputs

  • Specific power
  • kW per 100 cfm
  • Flow per input kW
  • Energy per operating hour

Engineering guide

Use the result with the right context.

Calculate compressor specific power, kW per 100 cfm, cfm per kW, and hourly electrical energy from measured input and FAD.

Calculation workflow
  1. Enter Measured package input power, Free air delivery, FAD unit and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Specific power, kW per 100 cfm, Flow per input kW against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • Reference pressure, temperature, humidity, and flow basis must stay consistent; standard and actual volume are not interchangeable.

  • Replace default correction factors with measured plant data and supplier ratings before equipment purchase.

FAQ

Questions about this calculation

01Tool noteWhat does the Compressor Specific Power Calculator calculate?

Calculate compressor specific power, kW per 100 cfm, cfm per kW, and hourly electrical energy from measured input and FAD.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Compressor Specific Power Calculator?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.