AI Search

Search this site

Mechanical units

Force and Torque Unit Converter

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison.

Mechanical units

Run the calculation

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison.

Engineering inputsForce & Torque Converter

Enter the known application values. Outputs update instantly as units or assumptions change.

Quantity type
Entered unit
Use these values for preliminary sizing before final datasheet review.

Engineering visual

Force & Torque Converter calculation path

The physical quantity stays unchanged while its numerical value and unit notation are expressed on equivalent scales.

Force & Torque Converter calculation pathThe physical quantity stays unchanged while its numerical value and unit notation are expressed on equivalent scales.SOURCE VALUE + UNITEQUIVALENT VALUEREFERENCE BASISTARGET UNITSAME PHYSICAL QUANTITY
  1. 01Quantity type
  2. 02Calculate and compare
  3. 03Primary SI result
Primary SI result
Secondary SI result
Primary imperial result
Gravitational or secondary imperial result

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Quantity type
  • Entered value
  • Entered unit

Outputs

  • Primary SI result
  • Secondary SI result
  • Primary imperial result
  • Gravitational or secondary imperial result

Engineering guide

Use the result with the right context.

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison.

Calculation workflow
  1. Enter Quantity type, Entered value, Entered unit and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Primary SI result, Secondary SI result, Primary imperial result against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • The converter changes units only and does not repair an incorrect gauge, absolute, standard, normal, or actual reference basis.

  • Keep the original datasheet reference conditions with the converted value.

FAQ

Questions about this calculation

01Tool noteWhat does the Force & Torque Converter calculate?

Convert force among N, kN, lbf, and kgf or torque among N·m, N·mm, lbf·in, and lbf·ft for pneumatic datasheet comparison.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Force & Torque Converter?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.