AI Search

Search this site

Machine air planning

Multi-Cylinder Air Demand and Capacity Planner

Combine two cylinder groups, actuator quantities, operating cycles, tube dead volume, concurrency, leakage reserve, future reserve, and selected supply capacity into one machine air-demand review.

Machine air planning

Run the calculation

Combine two cylinder groups, actuator quantities, operating cycles, tube dead volume, concurrency, leakage reserve, future reserve, and selected supply capacity into one machine air-demand review.

Engineering inputsMulti-Cylinder Air Demand Planner

Enter the known application values. Outputs update instantly as units or assumptions change.

Use these values for preliminary sizing before final datasheet review.

Engineering visual

Multi-Cylinder Air Demand Planner calculation path

The system schematic follows air from supply through storage and distribution to demand while preserving the selected reference pressure, temperature, and flow basis.

Multi-Cylinder Air Demand Planner calculation pathThe system schematic follows air from supply through storage and distribution to demand while preserving the selected reference pressure, temperature, and flow basis.SUPPLYSTORAGEp / VREFERENCE FLOW QDISTRIBUTED DEMAND
  1. 01Group 1 cylinder bore
  2. 02Calculate and compare
  3. 03Cylinder swept-volume demand
Cylinder swept-volume demand
Tube dead-volume demand
Concurrency-adjusted demand
Required design flow

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Group 1 cylinder bore
  • Group 1 rod diameter
  • Group 1 stroke
  • Group 1 cycles per minute
  • Group 1 actuator quantity
  • Group 2 cylinder bore
  • Group 2 rod diameter
  • Group 2 stroke
  • Group 2 cycles per minute
  • Group 2 actuator quantity
  • Available operating pressure
  • Tube inside diameter
  • Tube length per actuator
  • Simultaneous operating fraction
  • Leakage reserve
  • Future capacity reserve
  • Selected supply capacity

Outputs

  • Cylinder swept-volume demand
  • Tube dead-volume demand
  • Concurrency-adjusted demand
  • Required design flow
  • Selected supply utilization
  • Selected capacity margin

Engineering guide

Use the result with the right context.

Combine two cylinder groups, actuator quantities, operating cycles, tube dead volume, concurrency, leakage reserve, future reserve, and selected supply capacity into one machine air-demand review.

Calculation workflow
  1. Enter Group 1 cylinder bore, Group 1 rod diameter, Group 1 stroke and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Cylinder swept-volume demand, Tube dead-volume demand, Concurrency-adjusted demand against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • Reference pressure, temperature, humidity, and flow basis must stay consistent; standard and actual volume are not interchangeable.

  • Replace default correction factors with measured plant data and supplier ratings before equipment purchase.

FAQ

Questions about this calculation

01Tool noteWhat does the Multi-Cylinder Air Demand Planner calculate?

Combine two cylinder groups, actuator quantities, operating cycles, tube dead volume, concurrency, leakage reserve, future reserve, and selected supply capacity into one machine air-demand review.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Multi-Cylinder Air Demand Planner?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.