AI Search

Search this site

Slide cylinder selection

Guided Slide Cylinder Selection Wizard

Select a preliminary guided or slide cylinder bore and check offset moment plus end-of-travel kinetic energy against entered catalog limits in one workflow.

Slide cylinder selection

Run the calculation

Select a preliminary guided or slide cylinder bore and check offset moment plus end-of-travel kinetic energy against entered catalog limits in one workflow.

Engineering inputsGuided Slide Cylinder Selection Wizard

Enter the known application values. Outputs update instantly as units or assumptions change.

Travel orientation
Use these values for preliminary sizing before final datasheet review.

Engineering visual

Guided Slide Cylinder Selection Wizard calculation path

Read the cylinder cross-section from left to right: supply pressure acts on the piston area, the rod removes return-side area, and the two arrows show the available extension and retraction force.

Guided Slide Cylinder Selection Wizard calculation pathRead the cylinder cross-section from left to right: supply pressure acts on the piston area, the rod removes return-side area, and the two arrows show the available extension and retraction force.SUPPLY PRESSURE PBORE DROD dEXTEND FORCERETRACT FORCE
  1. 01Moving mass
  2. 02Calculate and compare
  3. 03Suggested standard bore
Suggested standard bore
Factored offset moment
Factored stopping energy
Guide-moment utilization

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Moving mass
  • Travel orientation
  • Additional external force
  • Guide friction coefficient
  • Required acceleration
  • Stroke length
  • Target travel time
  • Available operating pressure
  • Safety factor
  • Load center offset
  • Catalog allowable guide moment
  • Catalog allowable stopping energy

Outputs

  • Suggested standard bore
  • Factored offset moment
  • Factored stopping energy
  • Guide-moment utilization
  • Stopping-energy utilization
  • Average travel speed

Engineering guide

Use the result with the right context.

Select a preliminary guided or slide cylinder bore and check offset moment plus end-of-travel kinetic energy against entered catalog limits in one workflow.

Calculation workflow
  1. Enter Moving mass, Travel orientation, Additional external force and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Suggested standard bore, Factored offset moment, Factored stopping energy against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • The relationship is a first-pass rigid-body or elastic-member estimate; guides, joints, seals, and structural compliance can change the installed result.

  • Use pressure available at the actuator and verify mounting, cushioning, duty, speed, and catalog load limits.

FAQ

Questions about this calculation

01Tool noteWhat does the Guided Slide Cylinder Selection Wizard calculate?

Select a preliminary guided or slide cylinder bore and check offset moment plus end-of-travel kinetic energy against entered catalog limits in one workflow.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Guided Slide Cylinder Selection Wizard?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.