AI Search

Search this site

Actuator power

Pneumatic Cylinder Mechanical Power Calculator

Calculate instantaneous mechanical output, estimated pneumatic input, duty-adjusted average power, and horsepower from actuator force and speed.

Actuator power

Run the calculation

Calculate instantaneous mechanical output, estimated pneumatic input, duty-adjusted average power, and horsepower from actuator force and speed.

Engineering inputsPneumatic Power Calculator

Enter the known application values. Outputs update instantly as units or assumptions change.

Use these values for preliminary sizing before final datasheet review.

Engineering visual

Pneumatic Power Calculator calculation path

The sketch links airflow into the cap and rod chambers with piston travel, stroke distance, velocity, and elapsed cycle time.

Pneumatic Power Calculator calculation pathThe sketch links airflow into the cap and rod chambers with piston travel, stroke distance, velocity, and elapsed cycle time.AIRFLOW QSTROKE SVELOCITY vSTARTPOSITION AT t
  1. 01Actuator force
  2. 02Calculate and compare
  3. 03Mechanical output power
Mechanical output power
Estimated pneumatic input power
Duty-adjusted average power
Mechanical horsepower

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Actuator force
  • Linear speed
  • Overall efficiency
  • Operating duty cycle

Outputs

  • Mechanical output power
  • Estimated pneumatic input power
  • Duty-adjusted average power
  • Mechanical horsepower

Engineering guide

Use the result with the right context.

Calculate instantaneous mechanical output, estimated pneumatic input, duty-adjusted average power, and horsepower from actuator force and speed.

Calculation workflow
  1. Enter Actuator force, Linear speed, Overall efficiency and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Mechanical output power, Estimated pneumatic input power, Duty-adjusted average power against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • The relationship is a first-pass rigid-body or elastic-member estimate; guides, joints, seals, and structural compliance can change the installed result.

  • Use pressure available at the actuator and verify mounting, cushioning, duty, speed, and catalog load limits.

FAQ

Questions about this calculation

01Tool noteWhat does the Pneumatic Power Calculator calculate?

Calculate instantaneous mechanical output, estimated pneumatic input, duty-adjusted average power, and horsepower from actuator force and speed.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Pneumatic Power Calculator?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.