AI Search

Search this site

Valve sizing

Required Cv for Cylinder Stroke Time Calculator

Translate cylinder bore, rod, stroke, pressure, direction, target time, and allowed pressure drop into required free-air flow and valve Cv.

Valve sizing

Run the calculation

Translate cylinder bore, rod, stroke, pressure, direction, target time, and allowed pressure drop into required free-air flow and valve Cv.

Engineering inputsRequired Cv for Stroke Time

Enter the known application values. Outputs update instantly as units or assumptions change.

Stroke direction
Use these values for preliminary sizing before final datasheet review.

Engineering visual

Required Cv for Stroke Time calculation path

Upstream pressure drives flow through the valve restriction to downstream pressure. The restriction and pressure drop are shown at the component where they occur.

Required Cv for Stroke Time calculation pathUpstream pressure drives flow through the valve restriction to downstream pressure. The restriction and pressure drop are shown at the component where they occur.UPSTREAM p₁DOWNSTREAM p₂VALVE / ORIFICEFLOW QΔp = p₁ − p₂
  1. 01Cylinder bore
  2. 02Calculate and compare
  3. 03Required valve Cv
Required valve Cv
Equivalent required Kv
Required standard flow
Required flow in SCFM

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Cylinder bore
  • Rod diameter
  • Stroke length
  • Target stroke time
  • Working pressure
  • Allowed valve pressure drop
  • Stroke direction

Outputs

  • Required valve Cv
  • Equivalent required Kv
  • Required standard flow
  • Required flow in SCFM

Engineering guide

Use the result with the right context.

Translate cylinder bore, rod, stroke, pressure, direction, target time, and allowed pressure drop into required free-air flow and valve Cv.

Calculation workflow
  1. Enter Cylinder bore, Rod diameter, Stroke length and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Required valve Cv, Equivalent required Kv, Required standard flow against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • Air is treated as an ideal gas and the entered coefficient or geometry must match the supplier's stated reference conditions.

  • Confirm the entire flow path, including tubing, fittings, manifolds, silencers, and simultaneous valve demand.

FAQ

Questions about this calculation

01Tool noteWhat does the Required Cv for Stroke Time calculate?

Translate cylinder bore, rod, stroke, pressure, direction, target time, and allowed pressure drop into required free-air flow and valve Cv.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Required Cv for Stroke Time?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.