AI Search

Search this site

Shared passage

Valve Manifold Common-Passage Pressure Drop Calculator

Screen total flow, common-passage air velocity, pressure drop, and end pressure when multiple manifold stations operate together.

Shared passage

Run the calculation

Screen total flow, common-passage air velocity, pressure drop, and end pressure when multiple manifold stations operate together.

Engineering inputsManifold Pressure Drop Calculator

Enter the known application values. Outputs update instantly as units or assumptions change.

Flow unit
Use these values for preliminary sizing before final datasheet review.

Engineering visual

Manifold Pressure Drop Calculator calculation path

Upstream pressure drives flow through the valve restriction to downstream pressure. The restriction and pressure drop are shown at the component where they occur.

Manifold Pressure Drop Calculator calculation pathUpstream pressure drives flow through the valve restriction to downstream pressure. The restriction and pressure drop are shown at the component where they occur.UPSTREAM p₁DOWNSTREAM p₂VALVE / ORIFICEFLOW QΔp = p₁ − p₂
  1. 01Simultaneous active stations
  2. 02Calculate and compare
  3. 03Total simultaneous demand
Total simultaneous demand
Common-passage velocity
Estimated common-passage drop
Estimated end-station pressure

Calculation reference

Calculation method

Results are preliminary estimates. Actual operating conditions, component ratings, and the required safety margin determine whether a component is suitable.

Inputs

  • Simultaneous active stations
  • Flow per active station
  • Flow unit
  • Common-passage internal diameter
  • Effective passage length
  • Supply gauge pressure

Outputs

  • Total simultaneous demand
  • Common-passage velocity
  • Estimated common-passage drop
  • Estimated end-station pressure

Engineering guide

Use the result with the right context.

Screen total flow, common-passage air velocity, pressure drop, and end pressure when multiple manifold stations operate together.

Calculation workflow
  1. Enter Simultaneous active stations, Flow per active station, Flow unit and replace every default with application data.

  2. Run the calculation while keeping pressure, temperature, geometry, and reference states consistent.

  3. Interpret Total simultaneous demand, Common-passage velocity, Estimated common-passage drop against the supplier datasheet, machine risk, and an appropriate design margin.

Assumptions and limits
  • Air is treated as an ideal gas and the entered coefficient or geometry must match the supplier's stated reference conditions.

  • Confirm the entire flow path, including tubing, fittings, manifolds, silencers, and simultaneous valve demand.

FAQ

Questions about this calculation

01Tool noteWhat does the Manifold Pressure Drop Calculator calculate?

Screen total flow, common-passage air velocity, pressure drop, and end pressure when multiple manifold stations operate together.

02Tool noteCan I use the result as a final component selection?

No. These are preliminary estimates. Final selection also depends on supplier ratings, installation losses, transient conditions, applicable standards, machine risk, and validation testing.

03Tool noteWhy can a supplier calculation differ?

Supplier tools may use proprietary test curves, correction factors, rounding, leakage allowances, or reference conditions. Match those conditions and replace the defaults before comparing results.

04Tool noteWhat should I verify after using the Manifold Pressure Drop Calculator?

Check the entered units and reference conditions, then compare the calculated outputs with manufacturer ratings, application safety margins, transient loads, installation losses, and measured machine performance.